E-ware EW-5K100CO Manuel d'utilisateur télécharger pdf (Page 3)

Using your deep fryer

1. Introducing the oil or fat

z Open the top lid.

z Lift the basket using the handle.

z Place approximately 1.2 liters of oil into the deep fryer body (the level must always be

between the two marks on the oil container wall).

z If your use blocks of fat, cut them into pieces before placing them in the body.

z Set switch of the temperature controller to 300°F (the red Indicator light comes on).To

melt the fat needs roughly 6 minutes.

z Never attempt to melt fat in the basket.

2. Cooking

z Plug in the deep fryer.

z Set the temperature controller to the desired temperature depending on what you are

going to cook, the indicator “POWER” comes on.

z When the indicator “POWER” goes out (after approx 5-7 minutes) the deep fryer has

reached the corresponding temperature. Open the top lid.

z Attach the handle into basket.

z Put the food in the basket.

z Lower the basket into the oil slowly; watching the oil level and foam in order to keep them

from reaching the fringe of the oil container confirming the oil level is appropriate. Detach

the handle. Close the lid.

z When the food is cooked, turn anticlockwise the temperature controller to the position

“OFF”. Unplug the deep fryer or shut the power socket; the indicator “POWER”, goes out.

Open the lid. Attach the handle to basket’s support (at the top of the basket’s body), raise

the basket and drain the oil.

z When cooking, the temperature controller will heat or stop heating according to the set

temperature; the “POWER” indicator light will flicker.

3. Cleaning

z Unplug the appliance when cleaning.

z Clean the outside of the deep fryer and the lid with a damp cloth.

z Never use abrasive pads or alcohol.

z Detach the handle from the basket.

z Wash the basket with hot water or washing-up liquid. Rinse and dry carefully.

z Never immerse the appliance in water or water or wash it directly by water.

1 2 3 4

Pas de commentaire

E-ware EW-5K100CO Manuel d'utilisateur Page 3